User Manual
Table Of Contents
- NXR-ZGW/-ZRPNetLinx ZigBee Compatible Gatewayand Repeater
- Overview
- Installation
- Setting up a Network
- NXR-ZGW Browser-based Configuration Manager Pages
- Summary of Gateway Settings
- Configuration
- Personal Area Network (PAN)
- Network
- Enabling and disabling the wireless network
- Setting the PAN channel
- Security
- Access List
- Connections
- Finding a device’s EUI address
- Finding the device’s description
- Determining the device type
- Finding the amount of time a signal takes from the device to the gateway and back
- Determining the device link quality
- Checking the device link status
- PAN Device Details
- Putting a device on the Access List
- Removing a device from the Access List
- Locating the device
- Changing a Connected Device description
- Changing a device’s ZigBee networking information
- Utilities
- Device Configuration
Overview
2
NXR-ZGW/-ZRP
NXR-ZGW (FG5791-01) Specifications (Cont.)
Rear Components:
Power connector Two power options are available:
• 2-pin 3.5mm Phoenix connector
• Power Over Ethernet (PoE) - powers the device through the CAT5 cable.
Both Power and Data can be transmitted simultaneous through the CAT5
cable when using the appropriate equipment.
Ethernet port 10/100M (RJ-45) connector - used to connect the NXR-ZGW to your LAN
and/or to connect your third party device to the LAN when the NXR-ZGW is
used as a gateway.
Certifications: • FCC ID: CWU-ZGW
• IC ID: 5078A-ZGW
•CE
• IEC-60950
Operating/Storage
Environments:
• Operating Temperature: -30°C (-22°F) to 70°C (158°F)
• Relative Humidity: 5% to 85% non-condensing; intended for indoor use only
Included Accessories: • 2.4GHZ, MONO, RSMA, 3.5IN, 2.0DBI Antenna (70-0012-SA)
• Rubber feet
• Velcro mounting strip
Other AMX Products: • Mio Modero R-3 Remote (FG148-03)
• Mio Modero R-4 Remote (FG148-04)
• NXR-ZRP NetLinx ZigBee Repeater (FG5791-02)
• NXA-WAP 2403A (FG2255-20)
• NXA-WAP 2405A (FG2255-21)
• NXA-WAP 2413A (FG2255-24)
FIG. 1
Front and Rear Components of the NXR-ZGW
PoE PWR
12VDC
ETHERNET
PWR/STATUS
LAN
RF
ANT ID
(Front)
(Rear)
ID Button
Antenna Mount
2-pin 3.5mm Phoenix
10/100M
(RJ-45) connector
Connection LEDs
power connector