User Manual
Table Of Contents
- NXR-ZGW/-ZRPNetLinx ZigBee Compatible Gatewayand Repeater
- Overview
- Installation
- Setting up a Network
- NXR-ZGW Browser-based Configuration Manager Pages
- Summary of Gateway Settings
- Configuration
- Personal Area Network (PAN)
- Network
- Enabling and disabling the wireless network
- Setting the PAN channel
- Security
- Access List
- Connections
- Finding a device’s EUI address
- Finding the device’s description
- Determining the device type
- Finding the amount of time a signal takes from the device to the gateway and back
- Determining the device link quality
- Checking the device link status
- PAN Device Details
- Putting a device on the Access List
- Removing a device from the Access List
- Locating the device
- Changing a Connected Device description
- Changing a device’s ZigBee networking information
- Utilities
- Device Configuration
Device Configuration
31
NXR-ZGW/-ZRP
Device Configuration
Sending Firmware to The NXR-ZGW
Before beginning the Upgrade process
Set up and configure your NetLinx Master. Refer to your particular NetLinx Master
instruction manual for detailed setup procedures.
Prepare the communication on the NXR-ZGW for use. Refer to the Setting up a
Network section on page 11.
Refer to the NetLinx Studio version 2.4 or higher Help file for information on uploading
firmware files via Ethernet.
A NXR-ZGW which is not using a valid username and password will not communicate with a secured
Master. If you are updating the firmware on a keypad which is not using a username or password field,
you must first remove the Master Security feature to establish an unsecured connection.
If power or connection fails during a firmware upgrade, the file system may become
corrupted.