User Manual
Table Of Contents
- NXR-ZGW/-ZRPNetLinx ZigBee Compatible Gatewayand Repeater
- Overview
- Installation
- Setting up a Network
- NXR-ZGW Browser-based Configuration Manager Pages
- Summary of Gateway Settings
- Configuration
- Personal Area Network (PAN)
- Network
- Enabling and disabling the wireless network
- Setting the PAN channel
- Security
- Access List
- Connections
- Finding a device’s EUI address
- Finding the device’s description
- Determining the device type
- Finding the amount of time a signal takes from the device to the gateway and back
- Determining the device link quality
- Checking the device link status
- PAN Device Details
- Putting a device on the Access List
- Removing a device from the Access List
- Locating the device
- Changing a Connected Device description
- Changing a device’s ZigBee networking information
- Utilities
- Device Configuration
NXR-ZGW Browser-based Configuration Manager Pages
29
NXR-ZGW/-ZRP
1. In the menu on the top of the NXR-ZGW Browser-based Configuration Manager, select Traffic Log
under the section Utilities.
2. The description of each device is located in the column Description.
Determining the device type
1.
In the menu on the top of the NXR-ZGW Browser-based Configuration Manager, select Traffic Log
under the section Utilities.
2. The type of each device is located in the column Device Type.
Finding the device traffic
1.
In the menu on the top of the NXR-ZGW Browser-based Configuration Manager, select Traffic Log
under the section Utilities.
2. The traffic byte count of each device is located within the columns RX and TX. RX lists received
traffic, while TX lists transmitted traffic
Clicking on the EUI-64 number in the Traffic Log page will open the device’s PAN
Device Details page (see FIG. 13).