User Manual
Table Of Contents
- NXR-ZGW/-ZRPNetLinx ZigBee Compatible Gatewayand Repeater
- Overview
- Installation
- Setting up a Network
- NXR-ZGW Browser-based Configuration Manager Pages
- Summary of Gateway Settings
- Configuration
- Personal Area Network (PAN)
- Network
- Enabling and disabling the wireless network
- Setting the PAN channel
- Security
- Access List
- Connections
- Finding a device’s EUI address
- Finding the device’s description
- Determining the device type
- Finding the amount of time a signal takes from the device to the gateway and back
- Determining the device link quality
- Checking the device link status
- PAN Device Details
- Putting a device on the Access List
- Removing a device from the Access List
- Locating the device
- Changing a Connected Device description
- Changing a device’s ZigBee networking information
- Utilities
- Device Configuration
NXR-ZGW Browser-based Configuration Manager Pages
20
NXR-ZGW/-ZRP
Connections
All devices connected to the NXR-ZGW is displayed on this page.
Each device provides the following:
FIG. 12 Connections Page
Connections Page
No. The Netlinx ID number.
EUI-64 The 64 bit ZigBee EUI address of the device.
Description The device's description, supplied by the device.
Type The specific type of device being accessed.
Latency A measure of the amount of time (in milliseconds) for a message round-trip from the device to
the gateway and back.
LQI LQ is the link quality of the RF path between the PAN coordinator and the device. Quality
levels are:
• not recommended
• edge
• marginal
• good
Status The current status of the device: either "Active" or "Asleep".