User Manual
Table Of Contents
- NXR-ZGW/-ZRPNetLinx ZigBee Compatible Gatewayand Repeater
- Overview
- Installation
- Setting up a Network
- NXR-ZGW Browser-based Configuration Manager Pages
- Summary of Gateway Settings
- Configuration
- Personal Area Network (PAN)
- Network
- Enabling and disabling the wireless network
- Setting the PAN channel
- Security
- Access List
- Connections
- Finding a device’s EUI address
- Finding the device’s description
- Determining the device type
- Finding the amount of time a signal takes from the device to the gateway and back
- Determining the device link quality
- Checking the device link status
- PAN Device Details
- Putting a device on the Access List
- Removing a device from the Access List
- Locating the device
- Changing a Connected Device description
- Changing a device’s ZigBee networking information
- Utilities
- Device Configuration
NXR-ZGW Browser-based Configuration Manager Pages
14
NXR-ZGW/-ZRP
Checking the firmware version
The firmware version is listed on the Summary of Gateway Settings page of the NXR-ZGW Browser-
based Configuration Manager.
Checking the ZigBee firmware version
The ZigBee firmware version is listed on the Summary of Gateway Settings page of the NXR-ZGW
Browser-based Configuration Manager.
Determining the IP settings of the NXR-ZGW
1.
Browse to the Summary of Gateway Settings page of the NXR-ZGW Browser-based Configuration
Manager.
2. The IP settings are listed in the aptly-named section IP Settings.
Finding the ICSP device number of this unit
1.
Browse to the Summary of Gateway Settings page of the NXR-ZGW Browser-based Configuration
Manager.
2. The ICSP device number is listed under the section System Connection, Device ID.
Determining the PAN settings of the NXR-ZGW
1.
Browse to the Summary of Gateway Settings page of the NXR-ZGW Browser-based Configuration
Manager.
2. The PAN settings are listed in the aptly-named section PAN Settings.
Rebooting the Configuration Manager
1.
Browse to the Summary of Gateway Settings page of the NXR-ZGW Browser-based Configuration
Manager.
2. Click the Reboot button on the left bottom of the Summary of Gateway Settings page.
Summary Page (Cont.)
Pan ID The ZigBee personal area network ID used.
Security The current state of wireless security (Disabled/Enabled).
Access List The current state of the Access List (Disabled/Enabled).
Distribute Password Current mode of ZigBee password distribution (Disabled/Enabled).