User Guide

NXA-WAP250G

NXA-WAP250G 802.11b/g Wireless Access Point

Power Connector

The access point does not have a power switch. It is powered on when connected to the AC power

adapter, and the power adapter is connected to a power source. The power adapter automatically adjusts

to any voltage between 100-240 volts at 50 or 60 Hz. No voltage range settings are required.

Ethernet Port

The access point has one 10BASE-T/100BASE-TX RJ-45 port that can be attached directly to 10BASE-

T/100BASE-TX LAN segments. These segments must conform to the IEEE 802.3-2005 specifications.

This port supports automatic MDI/MDI-X operation, so you can use straight-through cables for all

network connections to PCs, switches, or hubs.

Reset Button

The Reset button is used to restart the access point or restore the factory default configuration. If you

hold down the button for less than 5 seconds, the access point will perform a hardware reset. If you hold

down the button for 5 seconds or more, any configuration changes you may have made are removed, and

the factory default configuration is restored to the access point.

NXA-WAP250G Specifications (Cont.)

Network Management Web-browser

Temperature • Operating: 0 to 50 °C (32 to 122 °F)

• Storage: -20 to 70 °C (32 to 158 °F)

Humidity 15% to 95% (non-condensing)

Compliances • FCC Part 15B Class B

• EN 55022 Class B

• EN 55024

• EN61000-3-2

• EN61000-3-3

Standards • IEEE 802.3-2005 10BASE-T, 100BASE-TX

• IEEE 802.11b, g

• Wi-Fi 11b/g, WPA, WPA2, WMM

Radio Signal Certification • FCC Part 15C 15.247, 15.207 (2.4 GHz)

• EN 300-328

• EN 301 489-1

• EN 301 489-17

• ARIB STD-T66

• IC RSS-210

Safety • EN 60950-1

• IEC 60950-1 (CB)

Included Accessories: • AC power adapter set (includes 4 plug snaps)

• Category 5 (CAT5) network cable

• NXA-WAP250G Installation Guide

• WallMount/Surface mounting installation kit (including two screws)