User Guide

System Configuration

NXA-WAP250G 802.11b/g Wireless Access Point

 DHCP Server/NAT Setting – Enables or disables the DHCP server and NAT on the NXA-

WAP250G. (Default: Enabled)

 Start/End IP Address – Specifies the start/end IP address of a range that the DHCP server

can assign to DHCP clients. You can specify a single address or an address range.

 Gateway – The IP address of the gateway router for the NXA-WAP250G, which is used if the

requested destination address is not on the local subnet.

 DNS IP Address – The IP address of a Domain Name Server on the network. A DNS maps

numerical IP addresses to domain names and can be used to identify network hosts by familiar

names instead of the IP addresses.

PPPoE

Many Internet service providers (ISPs) use the Point-to-Point Protocol over Ethernet (PPPoE) to

automatically assign an IP address to users with a DSL modem. The PPPoE page provides the settings

needed for this service (FIG. 28).

The displayed items on this page can be described as follows:

 PPPoE Setting — Enables the NXA-WAP250G IP address to be assigned automatically from

an Internet service provider (ISP) through an ADSL modem using PPPoE.

 Username — If your ISP has provided you with a PPPoE user name, enter it in the

corresponding text box.

 Password — If your ISP has provided you with a PPPoE password, enter it in the

corresponding text box.

FIG. 28 PPPoE Settings