User Guide

Installation
7
NXA-WAP250G 802.11b/g Wireless Access Point
Hardware Description
FIG. 7 shows the layout of the WAP250G connectors and components.
Reset Button Overview
The Reset Button (shown in FIG. 7) is used to either restart the WAP250G or restore the unit to its
factory default settings.
 If you hold down the button for less than 5 seconds, the WAP will perform a hardware reset.
 Is you hold down the button for more than 5 seconds, any current configuration changes and
settings (such as IP Address, MAC Address, security, etc.) are deleted and all of the unit’s
parameters are rest the factory defaulted settings.
LED Indicators
The access point includes three status LED indicators, as described in the following figure and table.
FIG. 4 NXA-WAP250G Component Locations
LED Status Description
POWER On Green Indicates that the system is working normally.
WLAN On/Flashing Green Indicates the 802.11g radio is enabled and transmitting or receiving data
through wireless links. The flashing rate is proportional to network activity.
Off Indicates the 802.11g radio is disabled.
LAN On/Flashing Green Indicates a valid link on the Ethernet port and that the access point is transmit-
ting or receiving data. The flashing rate is proportional to network activity.
Off
The Ethernet port has no valid link.
Power Socket
Ethernet LAN Port
(CAT5)
Antenna
Top View Bottom View
WallMount Slots
Reset Button