Specifications
Table Of Contents
- NXA-WAP1000Smart Wireless Access Point
- NXA-WAPZD1000 Smart Wireless Access Point
- NXA-WAPZD1000 Installation
- Preconfiguring the NXA-WAP1000
- Configuring for Management by NXA-WAPZD1000
- Configuring for Standalone Operation
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the NXA-WAP1000 to the Administrative Computer
- 3. Log Into the AP’s Web Interface
- 4. Configure the Wireless Settings
- Configure Common Wireless Settings
- Configure Wireless # Settings
- 5. Disconnect the AP from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Verify NXA-WAP1000 Operation
- Deploy the Access Point
- Troubleshooting Installation
- Browser-Based Configuration Pages
Browser-Based Configuration Pages
52
NXA-WAP1000 Smart Wireless Access Point
To enable other management access options:
1. Go to Administration > Management. The Management page appears (FIG. 34).
2. Review the access options, and then make changes as needed.
3. Click Update Settings to save your changes. A confirmation message appears at the top of the page.
Administration - Management page (Cont.)
TR069 / SNMP Management Choice:
Auto: Enables the NXA-WAP1000 device to connect to either an SNMP server, an
NXA-WAPZD1000 ZoneDirector, or a Ruckus Wireless FlexMaster.
SNMP only: Only allow SNMP management.
FlexMaster only: Only allow FlexMaster management.
DHCP Discovery: URL of server providing DHCP.
FlexMaster Server URL: URL of the FlexMaster server.
Digest-authentication
Username/Digest
authentication password
This information is automatically generated by the AP and used for
authentication with FlexMaster. Change this value only if you want the AP to
connect to another access control server (ACS).
Contact FlexMaster every: Interval at which the device should attempt to contact FlexMaster.
Associated-Clients
Monitoring Mode
When enabled, the AP monitors the association and disassociation activities of
wireless clients and sends this information to FlexMaster. Available options
include:
• Disable (default): Select to turn off client association monitoring. When this
option is selected, the AP will not send client association information to
FlexMaster; Flexmaster will need to retrieve this information from the AP.
• Passive: Select to enable client association monitoring and send related
information to FlexMaster at the next inform interval.
• Active: Select to enable client association monitoring and define the monitor
interval (Interval). The AP will check for client association based on the
defined Interval (in seconds), and then send related information to
FlexMaster as soon as an association event is detected.
TR069 Status: The current status of the Flexmaster connection.
Update Settings: Click this button to save your changes.