Specifications
Table Of Contents
- NXA-WAP1000Smart Wireless Access Point
- NXA-WAPZD1000 Smart Wireless Access Point
- NXA-WAPZD1000 Installation
- Preconfiguring the NXA-WAP1000
- Configuring for Management by NXA-WAPZD1000
- Configuring for Standalone Operation
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the NXA-WAP1000 to the Administrative Computer
- 3. Log Into the AP’s Web Interface
- 4. Configure the Wireless Settings
- Configure Common Wireless Settings
- Configure Wireless # Settings
- 5. Disconnect the AP from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Verify NXA-WAP1000 Operation
- Deploy the Access Point
- Troubleshooting Installation
- Browser-Based Configuration Pages
Browser-Based Configuration Pages
47
NXA-WAP1000 Smart Wireless Access Point
Upgrading Manually via FTP or TFTP
1.
In the Upgrade Method options, click FTP or TFTP. This opens either the FTP (FIG. 30) or TFTP
options.
2. Click the host name field and then type the URL of the server, or click the IP address field and then type
the IP address of the server. Remember to start the URL with ftp://.
3. Click Perform Upgrade. A status bar appears during the upgrade process.
4. After the upgrade is completed, you must manually reboot the AP.
Scheduling an Automatic Upgrade
1.
In the Upgrade Method options, click the button for your preferred choice.
2. Enter the appropriate information in the Host name field or IP address field.
FIG. 30 Maintenance - Upgrade - FTP page
FIG. 31 Maintenance - Upgrade - TFTP page
Do not change any of the Image Control File, Username, or Password entries.