Specifications
Table Of Contents
- NXA-WAP1000Smart Wireless Access Point
- NXA-WAPZD1000 Smart Wireless Access Point
- NXA-WAPZD1000 Installation
- Preconfiguring the NXA-WAP1000
- Configuring for Management by NXA-WAPZD1000
- Configuring for Standalone Operation
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the NXA-WAP1000 to the Administrative Computer
- 3. Log Into the AP’s Web Interface
- 4. Configure the Wireless Settings
- Configure Common Wireless Settings
- Configure Wireless # Settings
- 5. Disconnect the AP from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Verify NXA-WAP1000 Operation
- Deploy the Access Point
- Troubleshooting Installation
- Browser-Based Configuration Pages
Browser-Based Configuration Pages
42
NXA-WAP1000 Smart Wireless Access Point
Controlling Access to the Wireless Network
Access Controls give you control over which stations are allowed to join (associate with) your WLAN
networks. There are “tab” entries for each available WLAN.
Changing the Access Controls for a WLAN
1.
Go to Configuration > Radio 2.4G or Configuration > Radio 5G.
2. Click the Wireless # tab for the device for which you want to configure the access control settings.
3. Click the Edit Settings button after Access Control. The Configuration :: Wireless :: Access Control ::
Wireless # page appears (FIG. 26).
FIG. 26 Configuration - Radio 5G - Access Control