Specifications
Table Of Contents
- NXA-WAP1000Smart Wireless Access Point
- NXA-WAPZD1000 Smart Wireless Access Point
- NXA-WAPZD1000 Installation
- Preconfiguring the NXA-WAP1000
- Configuring for Management by NXA-WAPZD1000
- Configuring for Standalone Operation
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the NXA-WAP1000 to the Administrative Computer
- 3. Log Into the AP’s Web Interface
- 4. Configure the Wireless Settings
- Configure Common Wireless Settings
- Configure Wireless # Settings
- 5. Disconnect the AP from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Verify NXA-WAP1000 Operation
- Deploy the Access Point
- Troubleshooting Installation
- Browser-Based Configuration Pages
Browser-Based Configuration Pages
41
NXA-WAP1000 Smart Wireless Access Point
Rate Limiting
Rate Limiting allows you to cap the data transfer rates per client for a specific WLAN.
To enable per station rate limits:
1. Go to Configuration > 2.4G or Configuration > 5G.
2. Select the WLAN that you want to configure from the tabs at the top of the page.
3. Click the Edit Settings button next to Rate Limiting.
4. The Rate Limiting page appears (FIG. 25).
5. Set the maximum Downlink and Uplink rate per station, or leave disabled if you do not want to limit
traffic rate per station in that direction.
6. The table below updates to show the maximum transfer rates for each traffic type.
7. Click Update Settings to save your changes.
FIG. 25 Rate Limiting