Specifications
Table Of Contents
- NXA-WAP1000Smart Wireless Access Point
- NXA-WAPZD1000 Smart Wireless Access Point
- NXA-WAPZD1000 Installation
- Preconfiguring the NXA-WAP1000
- Configuring for Management by NXA-WAPZD1000
- Configuring for Standalone Operation
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the NXA-WAP1000 to the Administrative Computer
- 3. Log Into the AP’s Web Interface
- 4. Configure the Wireless Settings
- Configure Common Wireless Settings
- Configure Wireless # Settings
- 5. Disconnect the AP from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Verify NXA-WAP1000 Operation
- Deploy the Access Point
- Troubleshooting Installation
- Browser-Based Configuration Pages
Browser-Based Configuration Pages
36
NXA-WAP1000 Smart Wireless Access Point
Configuring WLAN Settings
This section describes how to configure WLAN-specific settings, such as wireless availability, SSID,
encryption, and authentication.
To configure WLAN settings:
1. Go to Configuration > 2.4G or Configuration > 5G. The Configuration :: xx :: Common page appears.
2. Click one of the eight Wireless (#) tabs. The Configuration :: 2.4G :: Wireless (#) page appears (FIG. 17).
You can configure up to 8 SSIDs per radio (16 on dual radio APs).
3. Review the WLAN options, and then make changes as required.
4. When you are finished, click Update Settings to save and apply the changes. A confirmation message
appears at the top of this page.
5. Click Go back to Wireless Configuration to reopen the previous page.