Specifications
Table Of Contents
- NXA-WAP1000Smart Wireless Access Point
- NXA-WAPZD1000 Smart Wireless Access Point
- NXA-WAPZD1000 Installation
- Preconfiguring the NXA-WAP1000
- Configuring for Management by NXA-WAPZD1000
- Configuring for Standalone Operation
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the NXA-WAP1000 to the Administrative Computer
- 3. Log Into the AP’s Web Interface
- 4. Configure the Wireless Settings
- Configure Common Wireless Settings
- Configure Wireless # Settings
- 5. Disconnect the AP from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Verify NXA-WAP1000 Operation
- Deploy the Access Point
- Troubleshooting Installation
- Browser-Based Configuration Pages
Browser-Based Configuration Pages
21
NXA-WAP1000 Smart Wireless Access Point
Status
The Status section of the Menu displays the current status and availability of the NXA-WAP1000.
Device
The Device page displays a general overview of the AP’s current status, including device name, serial number,
MAC address, current software version, etc.
FIG. 8 Status - Device page
Device
Device Name: The current name of the device. The device name identifies the AP among
other devices on the network.
Device Location: The address or location where the device is deployed.
GPS Coordinates: The latitudinal and longitudinal coordinates of the device location.
MAC Address: The MAC address for the NXA-WAP1000.
Serial Number: The serial number for the NXA-WAP1000.
Software Version: The current software version being used by the NXA-WAP1000.
Uptime: The current amount of time (in days, hours, minutes, and seconds) in which the
NXA-WAP1000 has been online.
Current Time: The current time of the latest refreshing of the Device page.
Ruckus ZoneDirector IP
Address:
If the NXA-WAP1000 is connected to an NXA-WAPZD1000 ZoneDirector, this
field displays the ZoneDirector’s IP address.
Ruckus ZoneDirector MAC
Address:
If the NXA-WAP1000 is connected to an NXA-WAPZD1000 ZoneDirector, this
field displays the ZoneDirector’s MAC address.