Specifications

Browser-Based Configuration Pages
30
NXA-ENET8POE Gigabit PoE Ethernet Switch
Trunks
From the Trunks section, you can select ports to group into static trunks, configure trunk connection settings,
configure Link Aggregation Control Protocol (LACP) on the NXA-ENET8POE, and show the LACP groups
status.
Membership
This page allows you to create a maximum of four trunks of up to eight ports per trunk. The Membership Table
has one row for each port and six columns. Each row contains five radio buttons which are used to indicate to
which trunk (if any) the port belongs.
FIG. 20 Trunks - Membership page
Trunks - Membership page
Port: The front panel port number.
Not a Trunk Member:
If the radio button in this column is selected, the port is not a member of any
trunks. This is the default state.
Trunk T1-T4:
These columns correspond to the four trunks that are supported by the switch.
To assign a port to a trunk, click on the radio button in the corresponding
column, then click APPLY.
Help:
Links directly to web help.
Apply:
Sets specified values to the system.
Cancel:
Discards all changes and restores current values.