Specifications

Browser-Based Configuration Pages

NXA-ENET8POE Gigabit PoE Ethernet Switch

LAN Settings

This section describes how to configure an initial IP interface for management access over the network. The IP

address for this device is 192.168.2.10 by default. To manually configure an address, you need to change the

switch’s default settings (IP address 192.168.2.10 and netmask 255.255.255.0) to values that are compatible

with your network. You may also need to a establish a default gateway between the switch and management

stations that exist on another network segment (if routing is not enabled on this switch).

FIG. 12 System - LAN Settings page

System - LAN Settings page

Change IP Address:

DHCP Enabled:

Check the box to enable DHCP (default: enabled).

LAN IP Address:

Address of the VLAN interface that is allowed management access. Valid IP

addresses consist of four numbers, 0 to 255, separated by periods. (Default:

192.168.2.10)

Subnet Mask:

This mask identifies the host address bits used for routing to specific subnets.

(Default: 255.255.255.0)

Gateway IP Address:

IP address of the gateway router between this device and management

stations that exist on other network segments. (Default: 0.0.0.0)

Management VLAN:

ID of a configured VLAN (1-4093, no leading zeroes) through which you can

manage the device. By default, all ports on the device are members of VLAN

1. However, the management station can be attached to a port belonging to

any VLAN, as long as that VLAN has been assigned an IP address.

Help:

Links directly to web help.

Apply:

Sets specified values to the system.

Cancel:

Discards all changes and restores current values.