Specifications

NXA-ENET8POE Gigabit PoE Ethernet Switch

10/100/1000BASE-T Ports

The switch contains eight RJ-45 ports that operate at 10 Mbps or 100 Mbps, half or full duplex, or at 1000

Mbps, full duplex. Because all ports on the switch support automatic MDI/MDI-X operation, you can use

straight-through cables for all network connections to PCs or servers, or to other switches or hubs.

Each of these ports support auto-negotiation, so the optimum transmission mode (half or full duplex), and data

rate (10, 100, or 1000 Mbps) can be selected automatically. If a device connected to one of these ports does not

support auto-negotiation, the communication mode of that port can be configured manually.

SFP Slot

The Small Form Factor Pluggable (SFP) transceiver slot is shared with RJ-45 Port 8. If an SFP transceiver

(purchased separately) is installed in the slot and has a valid link on its port, the associated RJ-45 port is

disabled and cannot be used.

Port and Power Status LEDs

The NXA-ENET8POE includes a display panel (FIG. 1) for key system and port indications that simplify

installation and network troubleshooting.

Power Supply Socket

The power socket is located on the rear panel of the NXA-ENET8POE (FIG. 1). The standard power socket is

for the AC power cord.