User's Manual

Port Configuration
85
NXA-ENET24 - Software Management Guide
Port Configuration
Overview
You can use the Port Information or Trunk Information pages to display the current connection status,
including link state, speed/duplex mode, flow control, and auto-negotiation.
Displaying Connection Status - Web
Click Por t, Port Information or Trunk Information.
Field Attributes (CLI)
Field Attributes (Web)
• Name: Interface label.
•Type: Indicates the port type (10BASE-T, 100BASE-TX, 100BASE-FX, 1000BASE-LX,
1000BASE-GBIC).
• Admin Status: Shows if the interface is enabled or disabled.
• Oper Status: Indicates if the link is Up or Down.
• Speed Duplex
Status:
Shows the current speed and duplex mode. (Auto, or fixed choice)
• Flow Control
Status:
Indicates the type of flow control currently in use. (IEEE 802.3x, Back-Pressure or None)
• Autonegotiation: Shows if auto-negotiation is enabled or disabled.
•Trunk Member: Shows if port is a trunk member. (Port Information only.)
• Creation: Shows if a trunk is manually configured. (Trunk Information only.) or dynamically set via
LACP.
FIG. 84
Web - Displaying Port/Trunk Information
Field Attributes (CLI)
Basic information:
• Port type: Indicates the port type. (10BASE-T, 100BASE-TX, 1000BASE-T, 1000BASE-SFP)
• MAC address: The physical layer address for this port. To access this item on the web, see the
Setting an IP Address section on page 13.
Configuration:
• Name: Interface label.
• Port admin: Shows if the interface is enabled or disabled (i.e., up or down).
• Speed-duplex: Shows the current speed and duplex mode. (Auto, or fixed choice)