User guide

NX2200 User Guide

7.0 SIM Chip Installation

Note: SIM chips are only used in GSM/GPRS equipped terminals.

1. The SIM chip slot is located with the terminal face down under the battery compartment. The

battery door must be removed by placing your finger on the ridges of the door and sliding down to

remove.

2. Remove the battery by placing a finger on the opening and pulling up. The battery will loosen and

fall out once the terminal is turned over.

3. There is only one working compartment be sure to use the one located on the top left side. The

SIM chip will be protected by a locking gate.

4. To open the gate, carefully use your fingernail or a small flathead screwdriver to slide the gate

from the LOCKED to the UNLOCKED position (slide down to unlock). The distance required is

about 1/8 inches or 3mm.

5. Once unlocked, use the square slot to open the gate. The gate is on a hinge and should NOT be

removed from the modem.

6. Once the gate is open, the SIM chip can be easily placed into the slot by inserting the card into

the grooves of the holder door. The metallic contact on the SIM card must be placed face down

(toward the contacts on the unit).

7. Close the door by pushing down and slide the gate up to lock it.