User guide

NX2200 User Guide

5.0 Installing a Paper Roll

A paper roll is required to print receipts and reports. The NX2200 uses thermal 2 ¼ x 1.38” paper rolls.

Follow the steps below to install a paper roll:

1. Place forefinger under flap at the bottom of the terminal and pull forward using force.

2. Using the tab lift compartment out.

3. Place the paper roll in the printer compartment.

4. Close the printer compartment door by pressing until it clicks into place.

6.0 Installing and Removing the Battery Pack

The power pack allows the terminal to operate when not connected to a power outlet. The NX2200 uses a

Lithium-ion battery. Average battery life is 12 hours (utilizing power saving features).

Follow the steps below to install the terminal’s battery pack:

1. Remove the battery door by placing your finger on the door, push down on the ridges and slide

down to remove.

2. Remove the battery by placing a finger on the opening and pulling up. The battery will loosen and

fall out once the terminal is turned over.

3. To install slide the battery under the locking tabs and push down.

4. Replace the battery door by inserting the top hedge in first, slide up until it snaps into place.