Specifications

On-Board WebConsole User Interface
20
NX-Series Controllers - WebConsole & Programming Guide
Accessing the WebConsole
From any PC that has access to the LAN that the target Master resides on:
1. Open a web browser and type the IP Address of the target Master in the Address Bar.
2. Press Enter to access WebConsole for that Master. The initial view is the Web Control page (FIG. 27).
Default User Names and Passwords
The following table lists the default user names and passwords for accessing the NX-series controllers through NetLinx
Studio or the WebConsole.
Device Tree
Click the Show Device Tree check box to show/hide the online device tree, which indicates all devices currently
connected to this Master. Use the plus and minus symbols to the left of each item in the Device Tree to expand the view
to include System devices, ports and individual Port settings.
At the Port view, you can use the Device Tree to make specific port assignments (including Channel and Level
assignments) (FIG. 29).
Note: NX-series controllers may list up to 22 ports depending on the model number of the controller. Not all listed port
numbers are valid. See the NX-Series Controllers Hardware Reference Guide for a list of valid port numbers for each
controller model.
Default User Names and Passwords
User Name Password
NetLinx Studio netlinx password
WebConsole administrator password
FIG. 29
Online Device Tree
(all collapsed)
(System devices expanded)
(NX-3200 ports expanded)
(NX-3200 Port 1 expanded)