Specifications

Initial Configuration
10
NX-Series Controllers - WebConsole & Programming Guide
Communicating via IP Address
Whether the on-board Master’s IP address was set or obtained via DHCP, use the IP address information from the
Network Addresses dialog to establish communication via the LAN-connected Master.
1. Use NetLinx Studio to obtain the IP address of the NX controller. If you do not have an IP address, follow the steps
outlined in either the Obtaining the NX Controller’s IP Address (using DHCP) section on page 8, or the Assigning a
Static IP to the NX Controller section on page 9.
2. Select Settings > Workspace Communication Settings from the Main menu to open the Workspace
Communication Settings dialog (FIG. 15):
3. Click System Settings to open the Communications Settings dialog. If you do not have a system selected, click the
Default Settings button (FIG. 16).
FIG. 15 NetLinx Studio - Workspace Communication Settings dialog
FIG. 16 NetLinx Studio - Communication Settings dialog (TCP/IP selected)