Specifications

Initial Configuration
7
NX-Series Controllers - WebConsole & Programming Guide
3. Click Get IP Information to enable the fields for editing (FIG. 9):
4. Enter the System, Device (0 for NetLinx Masters), and Host Name information.
Note: Host names may contain only the ASCII letters 'a' through 'z' (in a case-insensitive manner), the digits '0' through
'9', and the hyphen ('-').
5. To configure a network address via DHCP (FIG. 10):
a. Select Use DHCP.
b. Click Set IP Information to retain the DHCP setting.
c. To finish the process, click Reboot Device.
d. Click Done to close the dialog.
6. To specify a network IP address (FIG. 11):
FIG. 9 Network Addresses dialog showing initial IP information
FIG. 10 Network Addresses dialog (DHCP)
FIG. 11 Network Addresses dialog (Specify IP Address)