Specifications

Terminal (Program Port/Telnet) Commands
94
NX-Series Controllers - WebConsole & Programming Guide
Terminal Commands (Cont.)
Command Description
GET IP <D:P:S> Displays the IP configuration of a device.
If you enter GET IP without the D:P:S variable, the Master displays its D:P:S, Host
Name, Type (DHCP or Static), IP Address, Subnet Mask, Gateway IP, and MAC
Address.
Example:
>GET IP [0:1:50]
IP Settings for 0:1:50
HostName MLK-INSTRUCTOR
Type DHCP
IP Address 192.168.21.101
Subnet Mask 255.255.255.0
Gateway IP 192.168.21.2
MAC Address 00:60:9f:90:0d:39
GET PLATFORM INFO Retrieves information about a Master connected via USB port. The command
returns the master type, host name, system number, IPv4 address, IPv6 address,
MAC address, and serial number in a single response.
Example:
>get platform info
DESC=NX-3200;HOST=AMXM98BFB0;SYS=1;IP4=192.168.224.68;IP6=fe80::260:
9fff:fe98:bfb0;MAC=00:60:9f:98:bf:b0;SN='654321',0,0,0,0,0,0,0,0,0,0
HELP SECURITY Displays security related commands.
Note: This command is only available to Program Port terminal sessions. It is not
available to Telnet sessions (see the Overview section on page 90).
Example:
>HELP SECURITY
>logout Logout and close secure session
>setup security Access the security setup menus
ICSPMON ENABLED|DISABLED 
[PORT]
Enables or disables ICSP monitoring out the specified IP port. By enabling icspmon
on an IP port, an external application could connect to that port and "listen" on the
ICSP traffic.
IMPORT CONFIG Installs a previously exported config or clone file. The command searches the USB
media for config and clone .tar files and allows you to select which file to import. See
EXPORT (CONFIG|CLONE) TO USB (FRONT|BACK).
IMPORT IRL Loads an IRL file from USB media onto the masters flash file system. The command
searches the USB media for .irl files and allows you to select which IRL file to
import.
IMPORT KIT Installs a KIT file from USB media. The command searches the USB media for .kit
files and allows you to select which KIT file to import.
IMPORT TKN Installs a NetLinx token file from USB media. The command searches the USB
media for .tkn files and allows you to select which .tkn file to import.
IP STATUS Provides information about the current NetLinx IP Connections.
Example:
>IP STATUS
NetLinx IP Connections
No active IP connections
MANAGE FIRMWARE Telnet interface to load previous and factory firmware versions for both master
(device 0) and Integrated Device (device 5001)
Example:
>manage firmware
Devices
-------
0 - Master
5001
Select device or press return to cancel:0
Current Version: 1.2.259
Previous Version: 1.2.258
Factory Version: 1.2.250
To install a firmware version:
Enter P (Previous), F (Factory) or press return to cancel: