Specifications

Initial Configuration
13
NI & DVX Central Controllers - WebConsole & Programming Guide
4. Select Specify IP Address to enable the IP fields for editing (FIG. 17):
5. Verify that NetLinx appears in the Host Name field (if not, then enter it in at this time).
6. Enter the IP Address, Subnet Mask, and Gateway information into their respective fields (as defined by the System
Administrator).
7. Click Set IP Information to cause the on-board Master to retain this new IP Address.
8. Click Reboot Master.
9. Click Done to close the dialog.
Complete the communication process by continuing on to the Communicating Via IP Address section on page 14.
FIG. 17 NetLinx Studio: Network Addresses dialog (Specify IP Address)
Verify that these IP values are also entered into the related fields within either the 
IP Settings section of the System Connection page (on the touch panel) or within the
Address field on the web browser.
On the front panel of the NetLinx Master, the STATUS and OUTPUT LEDs should
begin to alternately blink during the incorporation. Wait until the STATUS LED is the
only LED to blink.