Specifications

Initial Configuration
10
NI & DVX Central Controllers - WebConsole & Programming Guide
Using the ID Button to Change the Master Device Value
Use the ID Button on the rear panel of the Controller in conjunction with ID Mode function in NetLinx Studio to
establish a NetLinx Device ID for the device. The steps described and the dialogs shown in this section are in the
NetLinx Studio application.
NetLinx Studio is available to download from www.amx.com.
Refer to the NetLinx Studio on-line help for information on using NetLinx Studio.
1. Access the Device Addressing dialog (FIG. 12) by selecting Diagnostics > Device Addressing.
2. Enter the system number in the Destination System field.
3. Enter the desired device number in the Change to Device box (Device field), and again enter the system number (in
the System field).
4. Click the Start Identify Mode button. This action activates Identify Mode on the named System.
The Device Addressing dialog displays the "Waiting...Press Cancel to Quit..." message, indicating that Identify
Mode is currently active (NetLinx Studio is waiting to detect a device - FIG. 13).
FIG. 12 Device Addressing dialog
"Identify Mode" means that the system is put on hold while it waits for an event from
any NetLinx device in the named system (for example, pushing the ID button on a
NetLinx device). The device that generates the first event is the device that gets
identified.
FIG. 13 Device Addressing dialog - Identify Mode active