Specifications

Initial Configuration
7
NI & DVX Central Controllers - WebConsole & Programming Guide
8. Note that the serial configuration is indicated in the Configuration text field (FIG. 6):
9. Click OK to close the Master Communication Settings dialog and return to the main application.
10. Right-click the Online Tree tab entry and select Refresh System: the Controller should appear in the Device Tree
(FIG. 7):
If not, verify that the Serial cable is connected properly, and that the Baud Rate settings on the Controller (set via
the Program Port DIP Switch) match the settings in NetLinx Studio.
Once Serial communication has been established, use NetLinx Studio to configure the Controller for LAN
Communication, as described below.
FIG. 6 Master Communication Settings dialog indicating a Serial Connection
FIG. 7 Online Tree indicating a Serial Connection