User manual

Chapter 2 Installation and Configuration

9. Slide the assembly into the NI 3100/3110, ensuring the riser mates

correctly to the main I/O board, as shown in the following figure.

10. Replace the two screws that hold the riser card onto the I/O board, as

shown in the preceding figure. Tighten the two screws to 0.41 N · m

(3.6 lb · in.) of torque.

11. Replace the three screws holding the expansion card retainer to the

housing. Tighten the three screws to 0.55 N · m (4.9 lb · in.) of torque.

12. Adjust the expansion card support bracket until the expansion card fits

snugly. Retighten the two screws securing the bracket to 0.55 N · m

(4.9 lb · in.) of torque.

13. Reconnect the 2.5 in. HDD or SSHD cable, noting the cable

orientation.

1Riser card retaining screw (×2)

2Riser card assembly

3 Main I/O board

4Bracket retaining screw (×3)

5Expansion card support bracket

screw (×2)