Specifications

Terminal (Program Port/Telnet) Commands
108
NetLinx Integrated Controllers- WebConsole & Programming Guide (FMv3)
Terminal Commands (Cont.)
Command Description
SET SSH PORT Sets the Master’s IP port listened to for SSH connections.
Note: The Master must be rebooted to enable new settings.
Example:
>SET SSH PORT
Current SSH port number = 22
Enter new SSH port number (Usually 22) (0=disable SSH):
Once you enter a value and press the ENTER key, you get the 
following message:
Setting SSH port number to 22
New SSH port number set, reboot the Master for 
the change to take affect.
SET TELNET PORT Sets the Master’s IP port listened to for Telnet connections.
Note: The Master must be rebooted to enable new settings.
Example:
>SET TELNET PORT
Current telnet port number = 23
Enter new telnet port number (Usually 23)
(0=disable Telnet):
Once you enter a value and press the ENTER key, you get the 
following message:
Setting telnet port number to 23
New telnet port number set, reboot the Master for
the change to take affect.
SET THRESHOLD Sets the Master's internal message thresholds.
This command will set the thresholds of when particular tasks are
pended. The threshold is the number of messages queued before a task
is pended.
Use extreme caution when adjusting these values.
Note: The Master must be rebooted to enable new settings.
Example:
>SET THRESHOLD
-- This will set the thresholds of when particular tasks are
pended. The threshold is the number of messages queued before
a task is pended.--
--Use extreme caution when adjusting these values.--
Current Interpreter Threshold = 2000
Enter new Interpreter Threshold (Between 1 and
2000)(Default=10):
Once you enter a value and press the ENTER key, you get the 
following message:
Current Lontalk Threshold = 50
Enter new Lontalk Threshold (Between 1 and 2000)
(Default=50):50
Current IP Threshold = 600
Enter new IP Threshold (Between 1 and 2000)
(Default=200): 600
Setting Thresholds to: Interpreter 2000
Lontalk 50
IP 600
New thresholds set, reboot the Master for the changes to take
affect.