Specifications

Terminal (Program Port/Telnet) Commands
103
NetLinx Integrated Controllers- WebConsole & Programming Guide (FMv3)
Terminal Commands (Cont.)
Command Description
SET ETHERNET MODE <CMD> This command sets the current LAN configuration.
• <CMD> = "auto" or <speed> <duplex> where
<speed> = 10 | 100 and <duplex> = full | half
Examples:
Set Ethernet mode auto
Set Ethernet mode 100 full
Set Ethernet mode 10 half
When new mode is set, unit will respond with:
Ethernet mode set. Change takes effect after reboot.
Note: See the GET ETHERNET MODE section on page 98.
SET FTP PORT Enables/Disables the Master’s IP port listened to for FTP connections.
Note: The Master must be rebooted to enable new settings.
Example:
>SET FTP PORT
FTP is enabled
Do you want to enable (e) or disable (d) FTP (enter e or d):
FTP enabled, reboot the Master for the change to take
affect.
SET HTTP PORT Sets the Master’s IP port listened to for HTTP connections.
Note: The Master must be rebooted to enable new settings.
Example:
>SET HTTP PORT
Current HTTP port number = 80
Enter new HTTP port number (Usually 80) (0=disable HTTP):
Setting HTTP port number to
New HTTP port number set, reboot the Master for
the change to take affect.
SET HTTPS PORT Sets the Master’s IP port listened to for HTTPS connections.
Note: The Master must be rebooted to enable new settings.
Example:
>SET HTTPS PORT
Current HTTPS port number = 443
Enter new HTTPS port number (Usually 443) (0=disable HTTPS):
Once you enter a value and press the ENTER key, you get the following
message:
Setting HTTPS port number to
New HTTPS port number set, reboot the Master for
the change to take affect.
SET ICSP PORT Sets the Master’s IP port listened to for ICSP connections.
Note: The Master must be rebooted to enable new settings.
Example:
>SET ICSP PORT
Current ICSP port number = 1319
Enter new ICSP port number (Usually 1319) 
(0=disable ICSP):
Once you enter a value and press the ENTER key, you get the 
following message:
Setting ICSP port number to
New ICSP port number set, reboot the Master for the
change to take affect.