Specifications

Configuration and Firmware Update

NI Connection and Firmware Updating

6. Click Reboot (from the Tools > Reboot the Master Controller dialog) and wait for the System

Master to reboot. The STATUS and OUTPUT LEDs should begin to alternately blink during

the incorporation. Wait until the STATUS LED is the only LED to blink.

7. Press Done once until the Master Reboot Status field reads *Reboot of System Complete*.

8. Click the OnLine Tree tab in the Workspace window to view the devices on the System.

The default System value is one (1).

9. Right-click the associated System number (or anywhere within the tab itself) and select

Refresh System. This establishes a new connection to the specified System and populates the

list with devices on that system.

10. Use Ctrl+S to save your existing NetLinx Project with the new changes.

Recommended NetLinx Device numbers

Using the ID Button to Change the Controller’s Device Value

1. Access the Device Addressing dialog (FIG. 35) by selecting Diagnostics > Device Addressing

from the Main menu.

If the Master does not appear in the Workspace window, make sure that the Master’s

System Number (from within the Device Addressing tab) is correctly assigned. If

there is a problem, use a system value of zero (0) on the Master.

• 1 - 255 • Axcess Devices use Axcess standards

• 301 - 3072 • NetLinx CardFrames start at frame number 25 - (frame# * 12) + Card #

• 5001 - 5999 • ICSNet NetLinx devices: NXI, NXM-COM2, NXM-IRS4, etc.

• 6001 - 6999 • ICSNet Landmark devices: PLH-VS8, PLH-AS16, PLB-AS16

• 7001 - 7999 • InConcert Devices

• 8001 - 8999 • PCLink Device: PCLink devices are PC programs

• 10000 - 31999 • ICSNet Panels: DMS, IMS, and future panels

• 33001 - 36863 • Virtual devices: these start at 33001

• 32001 - 32767 • Dynamic devices: the actual range used by Master

• 32768 - 36863 • Virtual devices: the actual range used by Master

FIG. 35 Device Addressing dialog (using the ID mode to set the NI Controller device value)

Enter the new Controller value

Assign the

new value to

the Controller