Specifications

Installation and Upgrading
27
NetLinx Integrated Controllers
5. Slide the unit into the rack until the attachment holes, along both sides, align to their
corresponding locations on the mounting brackets, as shown in FIG. 19.
6. Secure the AC-RK to the rack by using the four #10-32 screws (80-0186) and four #10 washers
(80-0342) supplied in the kit.
7. Apply power to the unit to complete the installation.
FIG. 19 Mounting Integrated Controller into an equipment rack
Install screws
Bracket
Rack
Mounting Holes
To prevent repetition of the installation, test the incoming wiring by connecting the
Controller’s connectors to their terminal locations and applying power. Verify that the
unit is receiving power and functioning properly. Disconnect the terminal end of the
power cable from the connected 12 VDC-compliant power supply.