Specifications

Installation and Upgrading

NetLinx Integrated Controllers

 You can choose to also remove the factory-installed mounting brackets by using a

grounded screwdriver to remove the two sets of screws securing these brackets

(B in FIG. 10).

3. Carefully pull-up and remove the housing from the Controller to expose the internal circuit

board (B and C in FIG. 10).

4. Place the housing aside for later re-installation and continue with the procedures in the

following sections to both remove the ICSNet cover plate and install the ICSNet Daughter

Card upgrade component.

Installing the ICSNet Card

1. Discharge any static electricity from your body by first touching a grounded metal object.

2. Locate the three internal ICSNet cover plate security flaps (FIG. 12).

3. Reach inside the unit and squeeze together the flap closest to the Compact Flash card.

4. Carefully repeat this process for the remaining two flaps.

5. Push out the ICSNet cover plate from the inside of the unit. This action dislodges the cover

plate and reveals the three ICSNet connector openings (FIG. 13).

The ICSNet cover plate is composed of material which allows it to be easily

malleable. The plate is made so that the flaps can be easily bent without using any

tools.

FIG. 12 ICSNet security flaps

Internal ICSNet

security flaps (3)

Do not use a metal tool to assist in this removal process. This plate can be

easily bent and can become damaged if reshaped in excess.