Specifications

Introduction
5
NetLinx Integrated Controllers
NI-2100 Specifications (Cont.)
Rear Panel Connectors
(Cont.):
Program port • RS-232 DB9 connector (male) can be connected to a DB9 port on a
computer; used with serial commands, NetLinx programming commands,
other DB9 capable devices, and to upload/download information from the
NetLinx Studio 2.4 program.
Configuration DIP switch • Sets the communication parameters for the Program port.
ID pushbutton • Provides the NetLinx ID (Device only) assignment for the device. Refer to
the Changing the Device Address of a NetLinx Device section on page 46.
• The D notation is used to represent a device number.
• The S notation is used to represent the System number of the Master.
Ethernet port • RJ-45 port for 10/100 Mbps communication. This port automatically
negotiates the connection speed (10 Mbps or 100 Mbps) and whether to
use half duplex or full duplex mode.
Ethernet Link/Activity LED • LEDs show communication activity, connection status, speeds, and mode
information:
SPD (speed) - Yellow LED lights On when the connection speed is 100
Mbps and turns Off when the speed is 10 Mbps.
L/A (link/activity) - Green LED lights On when the Ethernet cables are
connected/terminated correctly, and blinks when receiving Ethernet data
packets.
AXlink LED • Green LED indicates the state of the AXlink connector port.
• Normal AXlink activity = 1 blink/second
• Abnormal AXlink activity = cycle of 3 consecutive blinks and then Off
AXlink port • 4-pin 3.5 mm mini-Phoenix (male) connector provides data and power to
external control devices.
Power port • 2-pin 3.5 mm mini-Phoenix (male) connector
Included Accessories: • 2-pin 3.5 mm mini-Phoenix (female) PWR connector (41-5025)
• 4-pin 3.5 mm mini-Phoenix (female) AXlink connector (41-5047)
• 6-pin 3.5 mm mini-Phoenix (female) I/O connector (41-5063)
• 8-pin 3.5 mm mini-Phoenix (female) Relay connector (41-5083)
• Installation Kit (KA2105-01):
8-pin Relay Common Strip
Four rack mount screws
Four washers
• NI-2100 Quick Start Guide
• Two CC-NIRC IR Emitters
• Two removable rack ears (62-2105-07)
Other AMX Equipment: • 2-pin 3.5 mm mini-Phoenix male connector (41-5026)
• CC-NIRC IR cables (FG10-000-11)
• CC-NSER IR/Serial cables (FG10-007-10)
• CSB Cable Support Bracket (FG517)
• ICSNet daughter card (FG2105-10)
• NCK, NetLinx Connector Kit (FG2902)
• STS, Serial To Screw Terminal (FG959)
• Upgrade Compact Flash (factory programmed with firmware):
NXA-CF2NI256M - 256 MB compact flash card (FG2116-47)
NXA-CF2NI512M - 512 MB compact flash card (FG2116-48)
NXA-CF2NI1G - 1 GB compact flash card (FG2116-49)