Specifications

Programming - Telnet Commands
16
NXB-KNX NetLinx KNX Interface
Terminal Commands
The Terminal commands listed in the following table can be sent directly to the NXB-KNX via Telnet
terminal session.
In your terminal program, type "Help" or a question mark ("?") and <Enter> to access the Help Menu,
and display the Program port commands described below:
Terminal Commands
Command Description
----- Help ----- (Extended diag messages are OFF)
? or Help Displays this list of commands.
DATE Displays the current date and day of the week.
Example:
>DATE
10/31/2004 Wed
DISK FREE Displays the total bytes of free space available.
Example:
>DISK FREE
The disk has 2441216 bytes of free space.
DNS LIST <D:P:S> Displays the DNS configuration of a specific device including:
• Domain suffix·
• Configured DNS IP Information
Example:
>DNS LIST [0:1:0]
Domain suffix:amx.com
The following DNS IPs are configured
Entry 1-192.168.20.5
Entry 2-12.18.110.8
Entry 3-12.18.110.7
ECHO ON|OFF Enables/Disables echo (display) of typed characters.
GET JAVA HEAP Display the amount of memory allocated for Java pool.
This is the current Java memory heap size as measured in Mega-
bytes.
Example: a value of 5 = 5 MB.
GET ETHERNET MODE Displays the current ethernet configuration setting.
Settings are either "auto" in which the ethernet driver will discover it's
settings based on the network it is connected to OR <speed> and
<duplex> where speed is either 10 or 100 and duplex is either full or
half.
Example:
>GET ETHERNET MODE
Ethernet mode is auto.
Note: See SET ETHERNET MODE.
GET IP Displays the current IP configuration.
Example:
>GET IP
IP Settings
HostName MLK_INSTRUCTOR
Type DHCP
IP Address 192.168.21.101
Subnet Mask 255.255.255.0
Gateway IP 192.168.21.2
MAC Address 00:60:9f:90:0d:39
IPSEC ON|OFF|STATUS Enables/Disables IPSec security or displays current setting.