Instruction manual

Configuration
13
NXB-KNX KNX Communications Gateway
Click Accept to save your changes. Note that changes on this page take effect immediately.
Click Cancel to cancel any changes.
Clock Manager - Daylight Savings
Select Daylight Savings from the Clock Manager sub-menu (or from the main Clock Manager page), and the Daylight
Savings Manager page will be displayed (FIG. 19):
Note that this tab is enabled only if Network Time is selected (on the Mode Manager page).
The options on this page allow you to enable and disable daylight savings, and specify daylight savings start and end
times.
Click Accept to save your changes. Note that changes on this page take effect immediately.
Click Cancel to cancel any changes.
Clock Manager - NIST Servers
Time: Manually enter the current time (hh:mm:ss).
FIG. 19
Clock Manager - Daylight Savings Manager page
Daylight Savings: Use these radio buttons to turn daylight savings time on and off (default = Off).
Offset: Use these drop-down menus to specify the amount of time to offset the clock for
daylight savings.
Starts: These options allow you to specify when to start using daylight savings time. Select a
month and time to start from the drop-down menus.
• Select Fixed to start daylight savings at a specific Day, Month and Time (an additional
field for Day is provided when this radio button is selected).
• Select Occurrence to start daylight savings at a specified occurrence (additional
fields for Week of the Month, and Day of the Week are provided).
Ends: These options allow you to specify when to stop using daylight savings time. Select a
month and time to start from the drop-down menus.
• Select Fixed to end daylight savings at a specific Day, Month and Time (an additional
field for Day is provided when this radio button is selected).
• Select Occurrence to end daylight savings at a specified occurrence (additional fields
for Week of the Month, and Day of the Week are provided).