Instruction manual

Configuration
6
NXB-KNX KNX Communications Gateway
Accessing the NXB-KNX WebConsole via Zero-Config
Assuming that the NXB-KNX resides on the same LAN as the PC running NetLinx Studio, and the NetLinx Master to
which the NXB-KNX is connected, you can access the NXB-KNX via the Zero-Config feature in Netlinx Studio, as
described below:
1. In NetLinx Studio (version 3.0 or higher), right-click inside the Zero-Config tab of the Workspace Bar to access the
Zero-Config context menu (FIG. 7).
2. Select Refresh List to generate an initial listing of all Zero-Config devices detected (FIG. 8).
3. Click the plus symbol (+) to expand any device in the Zero-Config list. The device’s current IP Address is listed
below the device name (FIG. 8):
4. You can access any device in the Zero-Config list simply by double-clicking on it's entry. The selected device's
WebConsole (HTML) is displayed in a NetLinx Studio window.
5. The unit’s IP Address can be edited IP Settings page (see the IP Settings on page 10).
Accessing the WebConsole via Web Browser
From any PC that has access to the LAN that the NXB-KNX resides on:
1. Open a web browser and type the IP Address of the target NXB-KNX unit in the Address Bar.
2. Press Enter to access the WebConsole for the specified NXB-KNX unit. The initial view is the IP Settings page
(FIG. 5).
FIG. 7 NetLinx Studio - Zero-Config context menu
FIG. 8 Workspace Bar - Zero-Config tab