User Guide

NXF CardFrame and NetModules
4
NXF CardFrame, NetLinx Control Cards, and NetModules
NXS-NMS NetModules
The NXS-NMS NetModules (FG2009-10) accommodate one NetLinx Control Card, and connect
to the NetLinx bus via ICSNet connections. The NetModules offer a simple and economical way to
integrate additional functionality to control systems. FIG. 2 shows a NetModule shell and its main
components.
NXS-NMS NetModules specifications
The table below lists the NXS-NMS specifications.
Mounting modules into an equipment rack
To install the modules in an equipment rack using the optional AC-RK kit:
1. Remove the front faceplate from the module to expose the mounting holes.
2. Mount the module on the AC-RK bracket.
NUMBER: 16-bit integer represents the device number
PORT: 16-bit integer represents the port number (in the range 1 through the number of
ports on the Controller or device)
SYSTEM: 16-bit integer represents the system number (0 = this system)
FIG. 2 NXS-NMS NetLinx NetModule shell
NXS-NMS NetModules Specifications
Dimensions (HWD) 1.50" x 5.55" x 9.25" (3.81 cm x 14.10 cm x 23.50 cm)
ID button Generates an event from the NetModule to allow you to assign new
Device and System numbers, using ID mode in the NetLinx Studio soft-
ware program (see Using the ID button section on page 5 for details).
Control connector 20-pin black (male) connector that connects the NetModule to external
devices. These connectors are keyed to insure proper installation.
ICSNet RJ-45 connectors Receives power and data from a NetLinx Master/Hub ICSNet Port. An
ICSNet port on a NetLinx Master or Hub supplies up to 500 mA at 12 V
for module power.
12 VDC power supply connectors Two parallel male 2-pin (green) parallel connectors for 12 VDC power.
Enclosure Metal with black matte finish
Included Accessories NetLinx faceplate
Optional accessories AC-RK Accessory Rack Kit (holds up to three NetModules)
3
NXM-NMS
1720 1819 1516 1314 1012 11 896745
ID
NetModule
12
ICSNet PWR
12VDC
NetModule
ID Button
Parallel 12 VDC
2-pin power
supply connectors
Control Card slot
Control Card connector
ICSNet RJ-45 connectors
(20-pin)
front
rear