Instruction manual

Installing Wall-Mount (MXD) Panels

Modero X® Series G4 Touch Panels Instruction Manual

1. Prepare the area by removing any screws or nails from the drywall before beginning the cutout process.

2. After ensuring proper placement, cut out the mounting surface for the Backbox, using the included Installation

Template as a guide.

3. Thread the incoming Ethernet and USB cables through the surface opening (FIG. 44 and FIG. 45). Note that these

figures show a landscape panel but the installation of a portrait panel is essentially the same, other than the vertical

orientation.

Leave enough slack in the wiring to accommodate any re-positioning of the panel.

FIG. 44 shows the MXD-1000 Backbox installation:

Making sure the actual cutout opening is slightly smaller than the provided

dimensions is highly recommended. This provides a margin for error if the opening

needs to be expanded. Too little wall material removed is always better than too

much.

FIG. 44 MXD-1000 Backbox Installation (Landscape)

#4 Screws

4X Knock-Outs

Remove for Cable

Routing as Needed

4X Installation Clamp

for Wall Thickness

.31 [12.0] to .98 [.25.0]