User's Manual

Introduction
5
MVP-9000i Modero® Wireless Touch Panel with Intercom
Any wired connection intended for the device will be reconnected within approximately twenty seconds after
the device is placed in a Table Docking Station or Wall Docking Station. Depending upon its settings, the
device may be set to go into On Mode as soon as it is placed in the Docking Station.
Powering on the MVP-9000i
The MVP-9000i may be powered on by touching and holding the touchscreen. If the device was in Sleep
Mode, it will automatically turn on when put into a Table or Wall Docking Station.
Intercom Microphone
The MVP-9000i contains a built-in microphone above the upper lefthand corner of the touch screen for video
and audio conferencing capabilities. This microphone is concealed by the casing.
Stylus
The MVP-9000i comes with a unique touchscreen stylus that slides into a storage groove on the left side of the
device when not in use. Replacement styluses may be ordered in a 3-pack (black, FG5966-21; white, FG5966-
22) from www.amx.com.
Kick Stand
Since the MVP-9000i device is designed to be a unit used away from its docking station, it has an extendable
“kickstand” on the back of the unit (FIG. 2). This may be opened by physically lifting the free end of the kick
stand away from the device. The device may then be propped up on a flat surface and accessed in a normal
fashion.
Audio/Video Capabilities
The MVP-9000i has the capability of displaying multiple JPEG and PNG files at one time. The device also
supports streaming motion JPEG video (of the sort used by many IP and Web cameras) and hardware
acceleration of Motion JPEG (previously configured in TPDesign4), as well as MP3 and WAV audio files.
Power Management
The MVP-9000i utilizes a dual voltage external power supply. It may be recharged through the supplied PS3.0
Power Supply (FG423-30), as well as through the MVP-TDS-9 Table Docking Station (FG5967-1X) or the
MVP-WDS-9 Wall Docking Station (FG5967-1X). For more information, see the Accessories section on
page 11 for details.
When not in active use, the MVP-9000i conserves battery life between chargings. Pressing the touch screen
will return the device to its On Mode. For more information on the battery, see the Battery Life and
Replacement section on page 183.
Charging Lithium Polymer batteries at high temperature will reduce the battery life.
Industry guidelines dictate that batteries should not be charged at temperatures
above 45° C (113° F). The temperature is determined by a combination of the
ambient temperature where the panel is located, plus temperature increases
normally occurring inside electronic devices containing batteries. AMX has
implemented battery temperature monitoring features to maximize the rate of battery
charging, while staying within industry temperature guidelines.
Battery charge times will increase in installations where the room temperature is
above 25° C (77° F), and may be temporarily suspended at room temperatures
above 30° C (86° F). Battery charging will automatically resume once the
temperature has fallen to appropriate levels. Minimizing the display backlight intensity
and turning off the backlight during periods of non-use will also yield faster charge
times.
Although the MVP-9000i unit is equipped with a mini-USB port, the device cannot be
powered through the USB port. The port is only used for uploading firmware.