User's Manual

Configuring Communication
26
MVP-9000i Modero® Wireless Touch Panel with Intercom
7. Set up the security and communication parameters between the wireless card and the target WAP by
configuring the information on the second page of the WiFi tab. Refer to the following section for detailed
procedures to set up either a secure or unsecure connection.
Using the Site Survey Tool
This tool allows a user to “sniff out” all transmitting Wireless Access Points within the detection range of the
internal wireless card (FIG. 22). Once the Site Survey button is pressed, the device displays the Site Survey
page, which contains the following categories:
Network Name (SSID) - Wireless Access Point names
Channel (RF) - Channel currently being used by the WAP (Wireless Access Point)
Security (if detectable - such as WEP, OPEN and UNKNOWN) - Security protocol enabled on the
WA P
Signal - Displays the signal strength
MAC Address - Unique identification of the transmitting Access Point
To access the Wireless Site Survey page:
1. From the System Settings page, touch the WiFi tab.
2. At the bottom of the page, press the Next button to move to the second WiFi tab page.
3. Press the Site Survey button. This action launches the Wireless Site Survey page, which displays a listing
of all detected WAPs in the communication range of the internal card.
The card scans its environment every four seconds and adds any new WAPs found to the list. Every
scan cycle updates the signal strength fields.
Access points are tracked by MAC Address.
If the WAP’s SSID is set as a blank, then N/A is displayed within the SSID field.
If the WAP’s SSID is not broadcast, it will not show up on the Wireless Networks screen.
If a WAP is displayed in the list is not detected for 10 scans in a row, it is then removed from the
screen. In this way, a user can walk around a building and track access points as they move in and
out of range.
4. Sort the information provided on this page by pressing on a column name. This moves the sorting arrow
to that column, where it may be toggled up or down.
Up arrow - indicates that the information is being sorted in an ascending order.
Down arrow - indicates that the information is being sorted in a descending order.
FIG. 22 Wireless Site Survey page