User's Manual

Accessories
16
MVP-9000i Modero® Wireless Touch Panel with Intercom
3. Connect the PS-POE-AT High-Power PoE Injector to a power source. Connect the PS-POE-AT to an
Ethernet switch on the network via one length of Ethernet cable and insert one length of Ethernet cable
for connection to the Wall Docking Station.
4. Run the Ethernet cable through the knockout into the back box. Pull out about six inches (15.25cm) of
cable into the back box to facilitate installation of the MVP-WDS-9.
5. Slide the plastic back box into the hole, being careful not to twist or pinch the cable, and set it flush with
the wall.
Make sure that all of the lockdown wings are folded into their slots before attempting to insert the
box.
For ease of installation, the inside of the box has the direction “UP” labeled for reference.
6. Extend the wings on the sides of the box by tightening the screws inside the box.
Not all of the wings must be extended to lock the box in place, but extending a minimum of the top
and bottom wings is highly recommended.
Apply enough pressure to the screw head to keep the box flush with the wall: this ensures that the
wing will tighten up against the inside of the wall.
7. Attach the included snap-on ferrite to the Ethernet cable, as close to the RJ-45 connector as possible.
Attach the cable to the Ethernet Port (FIG. 13).
8. Firmly seat the device against the back box. Make sure that the tab connector at the bottom of the device
is locked into the back box.
9. Insert the two installation screws from the MVP-WDS-9 Installation Kit into the screw holes in the
interior compartment of the device and tighten them to anchor the device to the back box.
Make absolutely certain that the box is in its intended position. Once the box
lockdown wings are extended within the box’s hole within the wall, removing the box
will be extremely difficult without damaging the wall in the process.
The maximum recommended torque to screw in the wings on the plastic back box is
5 IN-IBS [5(NI-CM)]. Applying excessive torque while tightening the wing screws,
such as with powered screwdrivers, can strip out the wings or damage the plastic
back box.
FIG. 13 MVP-WDS-9 - Ethernet cable path
Knockout placement
in back box
Recommended Ethernet installation
Recommended USB installation
Ethernet port
Ferrite installation
position
Recommended
Ethernet cable
path
For ease of installation, put each screw on a neodymium magnet in the device’s
interior compartment to keep them on hand until they are needed.