User's Manual

Battery Life and Replacement
170
MVP-9000i Modero® Wireless Touch Panel with Intercom
To remove an old battery and replace it:
1. Remove the battery from its packaging, remove the protective film from the battery, and inspect it for any
damage or distortion. If the battery shows evidence of damage, contact AMX for replacement and proper
disposal information.
2. Place the device face-down on a surface that will not scratch the unit and gently pry up the IR emitter
cover at the screw slot at its bottom (FIG. 100).
3. Hold arefully press ln the left and right to loosen and remove the IR emitter cover.
4. Remove the two screws underneath the IR emitter cover (FIG. 101).
5. Remove the five screws on the back of the device. (FIG. 102).
Two of the screws are at the upper corners of the device, underneath rubber feet that also act as
screw covers. Remove the rubber feet to access the screws.
Lift up the kickstand and remove the label to reach the remaining three screws.
6. Discharge all static electricity that may have built up on your body, either by using a static discharge strap
or by touching a nearby piece of metal.
7. Carefully remove the back of the device and detach the battery lead at the battery connector (FIG. 103).
This will allow the back cover to be detached from the device.
FIG. 100 Removal of the IR emitter cover
FIG. 101 Location of screws under IR emitter cover
FIG. 102 Screw placement at the back of the MVP-9000i
Screw slot
Pry up on IR emitter cover
Screws under IR emitter cover
Two screws under upper screw covers
3 screws under label
(beneath kickstand)