User's Manual

Programming
110
MVP-9000i Modero® Wireless Touch Panel with Intercom
The origin of the transition is the point on the LCD where the motion originates. In most cases, these locations
are the top, bottom, left and right of the screen. For example, a slide transition with a left origin will appear to
slide in from the left towards the right of the screen.
Slide, slide with bounce, door with fade and center door with fade can originate from the top, bottom, left and
right sides of the screen. Black glass can originate from the left or right. Fade does not need an origin since the
entire screen fades together. Page curl originates from the four corners of the screen: upper left, lower left,
upper right and lower right.
The transition time is the amount of time required for the transition to operate from start to finish. This value
can be specified from 0.3 seconds to 3.0 seconds in tenths of a second. If not specified, the default is 1.5
seconds.
Transition times are based on real world clock time and do not vary based on the speed of the processor or the
frame rate at which the display system is running.
Since the transitions require OpenGL hardware acceleration, they are not seen by the user on a VNC
connection. When a transition is triggered, the user will see a normal page flip to the new page on the VNC
connection, while the animated transition occurs as expected on the panel.
Transition Classes (Cont.)
Center door with
fade
This transition operates as above, except that the hinge point is at the center of the LCD
rather than the edge.
Transition Commands
^AFP
Flips to a page
with the specified
page name using
an animated
transition.
Flips to a page with the specified page name using an animated transition. If the page is
active, do not redraw the current page. If the page name is blank, flips to the previous
page.
Syntax: "'^AFP-<page name>,<animation>,<origin>,<time>'"
Animation is one of the following strings: slide, sldBounce, blkGlass, fade, pgCurl, door-
Fade, cntrDrFade
If animation is blank or invalid, the page flip will occur without any animated transition
occurring.
Origin is a number representing one of the following values for where
the animated transition originates on the screen:
1 - center (currently unused)
2 - top
3 - bottom
4 - left
5 - right
6 - lower left
7 - lower right
8 - upper left
9 - upper right
If the origin is blank or invalid, the default is 5 (right).
Time is the transition time in tenths of a second which can vary from 3 (0.3 seconds) to 30
(3.0 seconds). Values above or below these values will be clamped. If the time is blank,
then the default is 1.5 seconds.
Example:
"'^AFP-MAIN,slide,5,10'"
Will transition to a page named MAIN using a slide effect from the right to the left and
taking 1 second to complete.