Specifications

Setup Pages
42
MVP-5200i Modero® ViewPoint® Touch Panel with Intercom, 5.2 and 5”
Navigation Buttons
The following Navigation buttons (FIG. 47) appear on the left side of the Setup page:
Setup Page (Cont.)
Connection Status icon: The icon in the upper-right corner of each Setup page provides a constant visual
indication of current connection status.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx
Master.
Connection Status: Displays whether the panel is has external communication, as well as the
encryption status of the Master, the connection type (
Ethernet or USB), and to
which System the panel is connected.
• Until a connection is established, the message displayed is: “
Attempting via
Ethernet
” or "Attempting via USB".
• When a connection is established, the message displayed is either: “
Connected
via Ethernet
“or “Connected via USB “.
• The word “
Encrypted” appears when an encrypted connection is established with
a NetLinx Master.
Note: The panel must be rebooted before incorporating any panel communication
changes and to detect Ethernet connections.
Inactivity Page Flip
Timeout:
Indicates the length of time that the panel can remain idle before automatically
flipping to a pre-selected page.
• Press the Up/Down buttons to increase/decrease the Inactivity Page Flip
Timeout setting. Range = 0 - 240 (minutes).
• Set the timeout value to 0 to disable Inactivity Page Flip mode.
Note: The touch panel page used for the Inactivity page flip is named within a
small Inactivity Page field below the buttons.
Panel Brightness: Sets the display brightness and contrast levels of the panel.
• Press the Brightness Up/Down buttons to adjust the brightness level.
Range = 0 - 100.
Note: Be careful not to turn down the brightness too low to be able to see the
Setup page.
Sleep Blink LED: Enables and disables the blinking of the navigation wheel LED when the device is
in Sleep mode. When enabled, the LED blinks while the device is charging. The
Sleep Blink LED button is enabled by default.
Note: This feature will only apply when the device is in Sleep mode. When the
device is active, the state of the LED will match that of the display.
FIG. 47 Setup Page Navigation Buttons
Press to access the Protected Setup pages.
Press to access the Project Information page in order to view information on
panel specific information such as resolution and memory.
Press to access the Time & Date page in order to alter the time and date settings on
the Master.
Press to access the Audio Settings page in order to adjust audio parameters
on the panel.
Press to access the Power Management page in order to monitor battery status in
the panel.
the TPDesign file being used, and the Panel Information page in order to view