Specifications

Configuring Communication
26
MVP-5200i Modero® ViewPoint® Touch Panel with Intercom, 5.2 and 5”
Manually entering the SSID information into the appropriate fields by following steps 7 through 9.
3. From within the Wireless Settings page, click the Simple button.
4. In the Security Type field, select Open (FIG. 23). An Open security method does not utilize any
encryption methodology, but does require that an alpha-numeric SSID be entered. This method sends out
network packets as unencrypted text.
5. Press the red SSID field to display an on-screen Network Name (SSID) keyboard.
6. In this keyboard, enter the SSID name used on the target Access Point (case sensitive).
The card should be given the SSID used by the target AP. If this field is left blank, the unit will
attempt to connect to the first available AP.
One of the most common problems associated with connection to a AP involves an incorrect SSID.
Make sure to maintain the same case when entering the SSID information. ABC is not the same as
Abc.
7.Click Done when complete.
8. From the Wireless Security: Simple Mode popup window (FIG. 23), press the Save button to incorporate
the new information into the device and begin the communication process.
9. Verify the proper configuration in the fields in the IP Settings section. Refer to Step 1: Configure the
Device’s Wireless IP Settings section on page 22 for detailed information.
10. Press the Back button to return to the Protected Setup page. Remember that the connection must be
configured to a target Master from the System Settings page.
11. After the panel restarts, return to the Wireless Settings page’s Information/Configuration section and
verify the signal level and signal level value.
FIG. 23 Wireless Security - Simple Mode
The Signal Level bar should provide some information regarding the strength of the
connection to a Access Point. If no signal is displayed, configuration of the network
could be required.