Specifications

Configuring Communication
25
MVP-5200i Modero® ViewPoint® Touch Panel with Intercom, 5.2 and 5”
Step 2: Configure the Card’s Wireless Security Settings
The second step in setting up the wireless card is to configure the Wireless Settings page. This section
configures both the communication and security parameters from the internal wireless card to the AP. The
procedures outlined within the following sections for an 802.11g card facilitate a common security
configuration to a target AP.
Refer to the Appendix B: Wireless Technology section on page 180 for more information on other security
methods.
After setting up the wireless card parameters, configure the communication parameters for the target Master;
see Ethernet Over USB section on page 29.
Configuring the Device’s Wireless Card for Unsecured Access To a WEP
In the Protected Setup page:
1. Press the Wireless Settings button (located on the lower-left) to open the Wireless Settings page
(FIG. 21).
2. Enter the SSID information by:
Automatically filling it by pressing the Site Survey button. From the Site Survey page, choose an
Open AP from within the Site Survey page and then pressing the Connect button at the bottom of
the page (FIG. 22).
FIG. 21 Wireless Settings page
FIG. 22 Site Survey of available APs
Select an OPEN
(unsecured) AP
Connecting to the
AP begins the
communication.
The Wireless Site Survey page will note the available security of each AP. If your AP
is not configured for Open security, you will not be able to connect in this security
mode.