Specifications

Configuring Communication

MVP-5200i Modero® ViewPoint® Touch Panel with Intercom, 5.2 and 5”

For more information on the Setup and Protected Setup pages, refer to the Setup Pages section on page 41 and

the Protected Setup Pages section on page 53.

Setting the Panel’s Device Number

In the Protected Setup page:

1. Press the Device Number field in the Device ID section to open the Device Number keypad.

2. The Master will assign the panel a new Device ID once connected. The default Device number is 0.

3. Press Done to return to the Protected Setup page.

4. Press Reboot to reboot the device and apply the new Device Number.

Wireless Settings - Wireless Access Overview

DHCP

When choosing DHCP, a DHCP server must be accessible before the fields are populated.

MVP touch panels connect to a wireless network through their use of the pre-installed AMX 802.11g wireless

interface card. This allows users to communicate with an Access Point (AP). The AP communication

parameters must match those of the pre-installed wireless interface card installed within the panel. This

internal card transmits data using 802.11x signals at 2.4 GHz. For a more detailed explanation of the security

and encryption technology, refer to the Appendix B: Wireless Technology section on page 180.

For more information on utilizing the AMX Certificate Upload Utility in conjunction with the EAP security,

refer to the AMX Certificate Upload Utility section on page 187.

FIG. 18 Protected Setup page

The default password for the Protected Setup page is 1988, but this may be changed

at any time.

If the SSID (Network Name) and WEP fields have not previously been configured, the

Wireless Settings page will not work until the panel is rebooted.