User guide

Chapter 2: Installation 17
3. Connect one end of a UTP cable into the RJ-45 port on your AMIQ
module. Route the cable to your AMX switch and connect the other end to
one of the available RJ-45 server ports. When the attached computer is
powered and a valid UTP connection is made to an AMX switch, the
green light on the AMIQ will illuminate.
4. Check the unique identifi er (UID) on the back of the AMIQ. Log the UID
and the target to which it is attached and keep this information for
future reference.
Repeat this procedure for every server that will be attached to your
AMX system.
To connect serial devices to the AMX system:
1. Locate an AMIQ-SRL module.
2. Attach the AMIQ-SRL 9-pin serial connector to the serial port of the
device to be connected to your AMX switch.
3. Attach one end of the CAT 5 cable to the RJ-45 connector on the AMIQ-
SRL module. Connect the other end of the CAT 5 cable to the desired
computer port on the back of your AMX switch.
NOTE: The AMIQ-SRL module is a DCE device and only supports VT100 terminal emulation.
4. Connect the power supply to the power connector on your AMIQ-SRL.
The cable expander can be used to power up to four AMIQ-SRL modules
from a single power supply.
5. Connect the AMIQ-SRL power supply to an appropriate AC wall outlet to
power up your serial device.
Repeat this procedure for every serial device that will be attached to your
AMX system.