Instruction manual

NetLinx Firmware Upgrades
74
Enova DVX-2150HD/2155HD All-in-One Presentation Switcher Operation/Reference Guide
4. Enter the Device ID number of the integrated device to be upgraded in the Device text box and the System ID
numbers for the DVX in the System text box.
The device number of the NetLinx Master is 0.
By default, the Device number assigned to the integrated control ports is 5001.
By default, the Device Number assigned to the integrated A/V switcher is 5002.
Use the Online Device Tree to determine the device's assigned IDs, if it has been changed.
5. Review the File, Connection, Address, and Target Device information before you send.
6. Click the Send button. You can watch the progress of the transfer in the Send to NetLinx Device dialog.
NetLinx Studio transfers the files to the DVX and then tells it to reboot. After it reboots, the DVX actually goes
through the upgrade process.
During the upgrade process, the Status LED blinks, and the DVX stays offline.
Once the upgrade is complete, the LED will stop blinking and the DVX will be online.
Repeat the firmware update process for the next device until all devices are updated.
Additional Documentation
For additional information on using NetLinx Studio, refer to the NetLinx Studio online help and
Operation/Reference Guide (available at www.amx.com).
Upgrading the Master or device firmware can take several minutes. If you are unsure
of the progress of the upgrade, you can see the status of the upgrade on the LCD
display on the front panel of the DVX.
If for any reason your Kit file transfer should fail, continue to retry the transfer until
you are successful. DO NOT reboot the DVX, or change connections until the
transfer is complete. Failure to complete this operation successfully may require a
factory repair of the DVX.